When something goes wrong with the wiring in your home, the first question is usually the same: can someone get out here, and what is it going to cost? We handle electrical repairs, panel work, and installations across Addison Township, and the price is explained on the call before anything gets scheduled. We are open every day from 9:00 AM to 8:00 PM.
Call (248) 791-9979 and tell us what you are seeing.
Addison Township is a town where the housing stock tends to run older, properties sit on larger lots, and outbuildings, garages, and additions are common. That shapes the kind of electrical work that comes up here. Panels that were sized for a different era, wiring that has never been updated, circuits that were added at some point without documentation - those are the calls we get, and they are the ones we are set up to handle. We cover this area the same way we cover the rest of Oakland County: you get a real price before we arrive, and the work is finished to code.
A lot of properties in this area have long driveways, detached garages, and outbuildings that sit well away from the main house. Running lighting circuits to those areas is a different job than adding a fixture to a finished room. We size the circuit for the full run, protect any outdoor connections properly, and make sure the fixtures are rated for the exposure they will face. Motion sensors, security floods, and landscape lighting along a path or driveway all start with the right circuit, not just the right fixture.
Ground-fault and arc-fault protection is required in kitchens, bathrooms, garages, and outdoor circuits, and the specific requirements have expanded over the years. Older homes in this area often have outlets in those locations that were installed before current code applied. We check what is there, confirm what protection is in place, and bring it up to where it needs to be. AFCI protection on bedroom and living area circuits is also part of this conversation, especially when a home is being updated or a panel is being replaced.
Battery-operated alarms are common in older homes, but hardwired alarms with battery backup are more reliable and are required in new construction and renovation work. We run the wiring, connect the alarms to a dedicated circuit, and make sure units in different rooms are interconnected so that one alarm triggers all of them. For a home with an attached garage or a fuel-burning heating system, carbon monoxide protection at the right locations matters as much as smoke detection.
Knob-and-tube wiring was standard in homes built through the early part of the last century, and a meaningful share of the older properties in this area still have it in some form. The system was not designed for today's loads, has no grounding conductor, and degrades over time in ways that are not always visible. Replacing it means running new circuits, updating the panel connections, and making sure the new wiring is grounded and protected throughout. We scope that work carefully because the condition of what is in the walls affects how the job goes.
Three-way switches control a single fixture from two locations, and they come up often in stairwells, hallways, and rooms with more than one entrance. Wiring them correctly requires understanding what is already in the wall, because the configuration varies depending on where the power enters the circuit. We also handle four-way switching for longer runs with more than two control points. If a switch is wired incorrectly, it usually shows up as a light that works from one location but not the other, and tracing that is part of the diagnostic work.
Adding an outlet where an extension cord has been running is a straightforward job that makes a real difference. We install standard outlets, GFCI outlets, 240-volt outlets for appliances and EV chargers, and USB outlets where they are useful. Replacing outdated two-prong outlets with properly grounded three-prong receptacles is common in older homes and requires confirming the circuit has a grounding path before the swap is made. Switch replacements follow the same logic: we confirm what is in the box before committing to a scope.
Don't let a small wiring issue turn into a fire risk. We'll take care of the circuits from here.
Scheduling starts on the call. You describe what is happening, we ask the questions needed to understand the job, and we confirm what the schedule allows. For most work, that means a day and a time that fits around the property being occupied. We are open every day from 9:00 AM to 8:00 PM, and short-notice calls are taken when the schedule has room.
Some electrical faults cannot wait: a panel that is producing heat or a burning smell, an outlet that sparked, a breaker that will not hold after being reset. When you call about a situation like that, we treat it as a priority and find the earliest available slot. We will tell you on the call what is available and what to do in the meantime, including which circuits to leave off until we arrive.
Properties in Addison Township include rental homes and properties where someone is working from home or running a small operation out of an outbuilding. When a job requires turning off power to part of the property, we plan that around the occupant's schedule where we can. Work that only requires isolating one circuit is handled differently from a full panel shutdown, and we explain which applies before the visit. We'll make your wiring safe again.
Dealing with a tripping breaker or a dead outlet means you want to know what the repair is going to cost before you commit to a visit. We give you a price on the call, based on what you describe and what the job involves. That price covers the scope as we understand it from the call.
What can change a quote is what we find once we are on site. A fault that turns out to be deeper in the wall than the symptom suggested, a panel that needs to be assessed before a new circuit can be added, or wiring that is in worse condition than expected are all things that affect the final scope. When something changes, we explain it before continuing. No-pressure estimates, priced up front, is how every job here starts.
Load calculations are part of any quote that involves adding circuits or upgrading a panel. Whether the existing service can carry what you are adding is a question that has to be answered before the work is scoped, not after. We do that on the call and confirm it on site.
A panel replacement, a service upgrade, or a whole-home rewire requires taking the main power off for a period. We plan that around the property's schedule, confirm the timing before the visit, and work through the job as efficiently as the scope allows. For a home with a home office or medical equipment that cannot be without power, we discuss that on the call and work out what preparation makes sense.
Most outlet work, lighting installations, and single-circuit repairs only require turning off the breaker for the affected circuit. The rest of the property stays live. That is the normal case for the kinds of jobs that come up most often in a residential property, and it means the visit is less disruptive than a full shutdown. We confirm which applies when we scope the job.
In a town where a lot of the housing stock was built decades ago, panels tend to be in basements, attached garages, or utility rooms that have accumulated other equipment around them. Access matters. A panel that is blocked by shelving, a water heater, or stored equipment takes longer to work on safely, and clearing the area before we arrive makes the visit go faster.
We also see panels in detached garages and outbuildings that serve as subpanels for those structures. If the outbuilding has its own panel, knowing its location and condition before the visit helps us scope the job accurately. When you call, we ask about the panel location and what is around it, because that information changes how the visit is planned. You're talking to someone who knows the area and the homes in it. We'll sort the wiring and clean up after.
Fast diagnosis. Pricing set out up front. Clean work. What the work involves is covered on the page covering our electrical services.
We cover Addison Township and the communities around it throughout this part of Oakland County. That includes Leonard, Oxford, Lake Orion, Bruce Township, and Oakland Township. The same range of electrical work applies across the area: panel upgrades, generator hookups, knob-and-tube replacement, outlet and lighting work, and everything in between.
Whether the property is in the town itself or in one of the neighboring communities, the call works the same way. You describe the job, we give you a price, and we schedule the visit. Electrical service scheduled without the runaround is the standard across the whole coverage area.
An electric gate operator needs a dedicated circuit run to the gate location, typically in conduit for outdoor protection. The circuit is sized for the operator's power requirements, and a GFCI-protected outlet is usually the connection point. We scope the run and the circuit requirements on the call.
Older homes in this area commonly have panels that are undersized for current loads, wiring that has never been updated, and outlets that lack the ground-fault protection now required in kitchens, baths, and garages. Knob-and-tube wiring shows up in the oldest properties, and circuits added over the years are sometimes undocumented. A call describing what you are seeing is the fastest way to figure out what the job actually involves.
Yes. Properties in this area often include detached garages, workshops, and outbuildings that have their own circuits or a subpanel. We handle wiring, outlet installation, lighting circuits, and subpanel work in those structures the same way we handle the main house. When you call, let us know if the work involves an outbuilding so we can scope it accurately.
Permit requirements depend on the scope of the work and the jurisdiction, and they vary between a township and the county around it. We confirm what applies to your specific job before the work starts, so you know what is required and what the process involves. That conversation happens on the call.
We answer when you call. We explain the work. We leave it safe.
If you are in Addison Township, Leonard, Oxford, Lake Orion, or anywhere in this part of Oakland County, call (248) 791-9979 to get a quote.
We are open every day from 9:00 AM to 8:00 PM. The price is confirmed before anything is scheduled. We cover this area, and the call is the place to start.
Other towns where we take electrical work: Oxford, Lake Orion, Bruce Township, Romeo, Brandon Township. See the whole of our area list.
Below is a plain-language look at the electrical work we handle across Addison Township, Oakland County and Oakland County. Each row covers what the service involves, who it fits best, and one practical thing worth knowing before you call. Pricing is discussed on the call, before anything is scheduled, so you can make an informed decision without any commitment.
| Service Type | What It Covers | Ideal For | Things to Know |
|---|---|---|---|
| Electrical Panel & Service Upgrades | 200-amp service upgradeNew breaker box installationLoad calculation and service entrance workSubpanel installation for garages and additions | Older Oakland County homes adding EV chargers, heating circuits, or major appliances to an undersized 100-amp panel | Panel work is finished to code and covers the full service entrance where the incoming capacity needs to match the new box. A load calculation is part of every upgrade. |
| Whole-Home Surge Protection | Panel-level surge suppressor installationFull-house circuit coverageProtection for EV chargers and appliancesPairing with panel upgrade work | Any Addison Township, Oakland County home exposed to utility fluctuations or ice storm outages that can send voltage spikes through the line | Installing surge protection while the panel is already open for an upgrade keeps the job efficient and covers every circuit in the house from a single device. |
| Dedicated Appliance Circuits | Dryer and range circuit installationRefrigerator and dishwasher circuitsWorkshop and garage circuitsPanel capacity check before installation | Homeowners adding a major appliance or workshop equipment that requires its own circuit | Every dedicated circuit starts with a panel capacity check. If the panel is already full, that conversation happens before the circuit work is quoted. |
Call (248) 791-9979 to describe the job and get a price before anything is scheduled. We are open every day from 9:00 AM to 8:00 PM.
(248) 791-9979